Search result
Operating this unit using the remote control of a TV
There are three ways to operate this unit using the remote control of a TV.
HDMI control function
Connect this unit to a TV that supports the HDMI control function with an HDMI cable and enable the HDMI control setting on the TV to perform basic operations on this unit (changing the input source, turning the power on and off, adjusting the volume) with the remote control of the TV.
Refer to “HDMI control function” for more information about the HDMI control function. link
Remote control preset function
If your TV is connected via optical, you may be able control the volume and mute functions on this unit from your TV without any further setup if your TV is one of supported brands.
Remote control learning function
If your TV does not support the HDMI control function, use this unit’s remote control learning function. This enables you to operate this unit with the remote control of a TV. (Using the remote control learning functionlink)
Using the remote control learning function
Press and hold the 
for 3 seconds or more until the voice guidance responds.
for 3 seconds or more until the voice guidance responds.Point the remote control of this unit at the remote sensor of this unit and press the remote control button to be learned (e.g. VOL +) once.
The voice guidance responds.
Point the remote control of the TV at the remote control sensor of this unit and press the remote control button to be learned (e.g. the button to increase the volume) 3 times.
If learning is successful, the status LED blinks in green once, and the voice guidance responds.
If learning is unsuccessful, the status LED blinks in red once. Repeat steps 2 and 3 if this happens.
When the status LEDs blink in white again, press the TV remote control button (e.g. the button to increase the volume) once more.
To learn a new function, repeat steps 2 and 3 with the next function.
Press and hold the main unit’s for 3 seconds.
for 3 seconds.The unit exits remote control learning mode.
Confirm that the operation (e.g. increasing the volume) can be performed on this unit with the TV remote control.
To delete all learned data, press and hold on the sound bar for 10 seconds.
Operations cannot be performed with the remote control learning function during the standby mode.
Other operations cannot be performed when in remote control learning mode.
Remote control learning may not be possible depending on the type of TV remote control.